Fitting the Engine

As you can see, the distribution covers from the Alfa engine are in the way of the apron and rear fender. I allready cut out a piece of the lip of the rear fender (standard width, in glassfiber), but that wasn’t enough. The rear fender is still sitting to high:

 

I had to remove the top left bolt that holds the cover to the engine, and I had to cut a piece out of the cover:

Now it (barely) fits, this picture isn’t entireley correct, it fits better than this:

I plan on making a cover around the distribution cover on the inside of the rear fender. This way no dirt can enter the distribution system.

 

Be the first to comment

Leave a Reply

Your email address will not be published.


*